EasyManuals Logo

DigiTech RP 150 User Manual

DigiTech RP 150
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
14
15
Stereo Mixer Setup
Computer Recording Setup
Outputs
Instrument Input
Powered
Studio Monitor
Powered
Studio Monitor
USB
Amp/Mixer switch
set to Mixer
Applying Power
Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to
a flat EQ response (on most amps, this would be 0 or 5 on the tone controls). Then follow the
steps listed below.
1. Turn the amp volume all the way down.
2. Connect the plug of the PS0913B power supply to the power jack on the rear panel of the
RP150.
3. Connect the other end of the PS0913B power supply to an AC outlet. Turn the RP150’s Mas-
ter Level knob (Knob 4) down to “0”.
4. Turn the power of your amplifier(s) to the on position and adjust the volume(s) to a normal
playing level.
5. Gradually increase the RP150’s Master Level knob to achieve the desired volume.
4. Turn amp volume up
1. Turn amp volume down
2. Connect PS0913B to power jack
3. Connect PS0913B to AC outlet
and turn the RP150’s Master
Level to “0”
5. Turn the RP150’s Master Level to the
desired listening volume

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DigiTech RP 150 and is the answer not in the manual?

DigiTech RP 150 Specifications

General IconGeneral
BrandDigiTech
ModelRP 150
CategoryMusic Pedal
LanguageEnglish

Related product manuals