Applying Power
There are two options for powering the RP100:battery power, and AC power. Before applying
power to anything,set your amp(s) to a clean tone and set the tone controls to a flat EQ
response (on most amps, this would be 0 or 5 on the tone controls).Then follow the steps listed
below.
Battery Power
The RP100 can be run for about 8 hours on 6 AA batteries.The battery compartment is located
on the bottom of the RP100.The following diagram shows the correct polarity for battery
installation.
Connecting your instrument to the Input of the RP100 will engage the battery power and
disconnecting your instrument from the Input of the RP100 will disengage the battery power.
Once the connections have been made,and the RP100 is powered (indicated by numbers
appearing in the Display),turn the RP100’s Master Level (far right knob) all the way down.Turn
your amplifier(s) power switch to the on position and adjust the volume(s) to a normal playing
level.Gradually increase the RP100 Master Level to achieve the desired volume. To prolong
the battery life,disconnect your instrument from the RP100’s Input when not in use .
8
To Next Page
Loading...
Need help?
General
