Rear Panel
1. Input - Connect your instrument to this jack.
2. 1/4” Outputs - Connect these outputs to your amplifier or direct to a mixing console that
accepts 1/4” unbalanced connections. Use the Left Output for all mono
applications.
Note: When using the RP80 direct into a mixer or recording device, or when using
it with headphones, you can enable the Global Cabinet Modeling feature to
emulate speaker simulation on each of the RP80’s presets. (See Page 23 for
more on Global Cabinet Modeling.)
3. Headphone Output - Connect a pair of stereo headphones to this 1/8” jack.
4. Power Input - Connect only the DigiTech PS200R power supply to this jack.
To Next Page
Loading...
