IMPORTANT SAFETY INFORMATION
DECLARATION OF CONFORMITY
Manufacturer’s Name: DigiTech
Manufacturer’s Address: 8760 S. Sandy Parkway
Sandy, Utah 84070, USA
declares that the product:
Product name: RPx400
Product option: all (requires Class II power adapter that conforms to
the requirements of EN60065, EN60742, or
equivalent.)
conforms to the following Product Specifications:
Safety: IEC 60065 (1998)
EMC: EN 55013 (1990)
EN 55020 (1991)
Supplementary Information:
The product herewith complies with the requirements of the Low Voltage
Directive 73/23/EEC and the EMC Directive 89/336/EEC as amended by
Directive 93/68/EEC.
Vice-President of Engineering
8760 S. Sandy Parkway
Sandy, Utah 84070, USA
Date:April 17, 2003
European Contact: Your local DigiTech Sales and Service Office or
Harman Music Group
8760 South Sandy Parkway
Sandy, Utah
84070 USA
Ph: (801) 566-8800
Fax: (801) 568-7583
WARNING FOR YOUR PROTECTION
PLEASE READ THE FOLLOWING:
KEEP THESE INSTRUCTIONS
HEED ALL WARNINGS
FOLLO
W ALL INSTRUCTIONS
DO NO
T USE THIS APP
ARATUS NEAR WATER
CLEAN ONL
Y WITH A DRY CLOTH.
DO NO
T BLOCK ANY OF THE
VENTILATION OPENINGS.
INSTALL IN ACCORDANCE WITH THE MANUFACTURER’S
INSTR
UCTIONS.
DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIA-
TORS,
HEAT REGISTERS, STOVES, OR OTHER APPARATUS
(INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.
ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE
MANUFACTURER.
UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR
WHEN UNUSED FOR LONG PERIODS OF TIME.
Do not defeat the safety purpose of the polarized or grounding-type
plug.
A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong.
The wide blade or third prong are provided for your safety. If the
pro
vided plug does not fit your outlet, consult an electrician f
or
replacement of the obsolete outlet.
Protect the po
wer cord fr
om being walked on or pinched particular
-
ly at plugs, convenience receptacles, and the point where they exit
from the apparatus.
Use only with the cart stand, tripod bracket, or table specified by the
manufacture, or sold with the apparatus. When a cart is used, use
caution when moving the car
t/apparatus combination to av
oid injury
from tip-over.
Refer all servicing to to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way, such as
power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been
dr
opped.
POWER ON/OFF SWITCH: For products provided with a power
switch, the power switch DOES NOT break the connection from the
mains.
MAINS DISCONNECT: The plug shall remain readily operable. For
rack-mount or installation where plug is not accessible, an all-pole
mains switch with a contact separation of at least 3 mm in each pole
shall be incorporated into the electrical installation of the rack or
building.
FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE
RECEPTACLE: Replace fuse with same type and rating only.
MULTIPLE-INPUT VOLTAGE:This equipment may require the use of
a different line cord, attachment plug, or both, depending on the avail-
able power source at installation. Connect this equipment only to the
power source indicated on the equipment rear panel. To reduce the
risk of fire or electric shock, refer servicing to qualified service per-
sonnel or equivalent.
U.K. MAINS
PLUG WARNING
A molded mains plug that has been cut off from
the cord is unsafe. Discard the mains plug at a
suitable disposal facility. NEVER UNDER ANY
CIRCUMSTANCES SHOULD YOU INSERT A
DAMAGED OR CUT MAINS PLUG INTO A 13
AMP POWER SOCKET. Do not use the mains
plug without the fuse cover in place. Replacement
fuse covers can be obtained from your local retail-
er. Replacement fuses are 13 amps and MUST be
ASTA approved to BS1362.
To Next Page
Loading...
Need help?
General
