22
Program Change
The VL3D can be configured to accept received Program Change messages, or
this capability can be turned off. The VL3D looks for Program Change mes-
sages on the Control Change MIDI channel as specified in the previous section.
After one second, PC on the Display will be replaced
by the current status of Program Change.
on indicates the VL3D will accept PC messages, pro-
vided the MIDI CC MIDI channel is not set to OF.
OF indicates that no received PC messages will be
processed.
Saving Global Parameters
The following Global Parameters are automatically saved when changed:
Guitar Sensitivity•
MIDI Channel•
MIDI Split Point•
MIDI Notes Mode Configuration (1-Channel or 4-Channel)•
MIDI CC Channel •
MIDI Program Change Enable•
External Footswitch
The VL3D supports the use of an optional external ¼” TRS three-button foot-
switch such as the DigiTech FS3X or FS300.
The buttons of the External Footswitch perform the following fixed functions:
Left footswitch: Toggle Harmony Bank A/B
Middle footswitch: Advance Harmony Patch
Right footswitch: Harmony On/Off
The VL3D also will support a single button footswitch provided it is a normally
open switch. In this case the switch will control Harmony On/Off.
To Next Page
Loading...
Need help?
General
