4. Use the Data Wheel, softkeys and keyboard to enter the new infor-
mation. The Arrow buttons are still active so you can make changes
to additional steps.
5. Press the Exit button twice to exit and store your changes if you
decide to keep them.
Naming Songs and Sections
Naming your song is important for your reference but not required by the
Vocalist Workstation EX.
If you plan to use the Arrangement editing feature you should assign
each section a name such as verse, chorus etc.. This will make it easier to
know where you are in performance and when it comes time to put the
sections together into an arrangement. To save you typing in each section
name, we have given you factory names from which you can choose.
To name a song:
1. Press the Songs button to enter Songs mode, and select the desired
song # with the Data Wheel.
2. Press the Edit button once.
3. Press the Name softkey.
4. The current name is shown on the second line. The softkeys are used
to move the cursor and to enter letters, numbers and symbols and the
Data Wheel is used to select data.
5. Press the Exit button twice and then Store; or Exit then Store to
save your changes.
To name a song section:
1. Press the Songs button to enter Songs mode.
2. Press the Edit button once.
3. Press the Right and Left Arrow buttons to locate which section you
want to name.
4. Press the Edit button.
5. Press the Name softkey. This presents the section naming screen.
6. Turn the Data Wheel to select the predefined name you want to
assign to the current section.
7. Press the Exit button twice and then Store to save your changes, or
the screen-labeled softkeys to discard edits. Press Exit to return to
Songs mode..
You have now created the first building block of a song. Depending on
the complexity of your song, you may be finished with programming at
this point.
54
To Next Page
Loading...
Need help?
General
