DIGITEN DHTC-1011 User Manual

Note: Before setting the parameters, please don’t connect any
load (whether it is heating / cooling equipment, or humidification /
dehumidication equipment).
For example
Turn on the heater at 76°F and turn o󰀨 at 80°F, turn on the humidier at
40% humidity and turn o󰀨 at 50%.
1. Press and hold the SET button for about 3 seconds until the
appears.
2. Short press the SET button to select the temperature.
3. Press the and button to set the RV to 76°F.
4. Short press the SET button to the SV value page.
Long press SET
button for 3s
Run temperature
Stop temperature
Alarm low temperature
Alarm high temperature
Compressor Delay
time(mintures)
Temperature
Calibration
SET
SET
SET
SET
SET
SET
Long press SET
button to save
Run value
Stop value
Alarm high humidity
Alarm low humidity
Humidity Calibration
SET
SET
SET
SET
Long press SET
button to save
Setup Flow Chart

DIGITEN DHTC-1011 Specifications

General

Brand	DIGITEN
Model	DHTC-1011
Category	Controller
Language	English