Digittrade HS256S User Manual

English
60
The necessary power supply for the HS256S is provided by USB or FireWire. It is
not neccessary to use an additional power supply. In case your used connecter
cannot provide enough power it is possible to use an additional power supply.
If the HS256S is connected correctly to the computer the LED “ACTIVE”,
“STATUS” and “ERROR” will flash once.
The DIGITTRADE HS256S is now ready for use, but still needs to get unlocked. For
this keep your smart card and smart card PIN ready.
Note: For security reasons please use only original accessories in combination with
your DIGITTRADE HS256S.
After the DIGITTRADE HS256S is ready for use it still needs to get unlocked.
To accomplish this insert the smart card into the smart card slot in direction of the
arrow.
If a valid smart card is inserted
the “STATUS“-LED will flash
once. Afterwards the keypad is
lighted and ready for the PIN
entry.
If an invalid smart card is
inserted the “ERROR“-LED
flashes.
3. Getting started with the HS256S
3.1 Inserting the smart card

Digittrade HS256S Specifications

General

Brand	Digittrade
Model	HS256S
Category	Storage
Language	English