Convert a
Digitus USB - Serial adapter, USB 2.0
Chipset: FTDI / FT232RL
Into a simple and pricey 1-Wire adapter
Note: I give no guarantee of anything nor for the accuracy of any information provided. I also reject any liability for
damage that may have been caused by use of this document - directly or indirectly.
Open the case and the screws:
Use a knife and open the case gently:
Unsolder the grey wire: take a saw and cut the board here:
Unsolder SP213ECA (RS232 Transceiver). Add a lot of solder to both sides as shown, :
To Next Page
