7
Installation of the Switch
This part describes how to install your Ethernet Switch and
make connections to it. Please follow the following
instructions to avoid incorrect installation causing device
damage and security threat.
• Before cleaning the switch, unplug the power plug of the
switch first. Do not clean the switch with wet cloth or
liquid;
• Do not place the switch near water or any damp area.
Prevent water or moisture from entering the switch
chassis;
• Do not place the switch on an unstable case or desk. The
switch might be damaged severely in case of a fall;
• Ensure proper ventilation of the equipment room and
keep the ventilation vents of the switch free of
obstruction;
• Make sure that the operating voltage is the same one
labeled on the switch;
• Do not open the chassis while the switch is operating or
when electrical hazards are present to avoid electrical
shocks
To Next Page
Loading...
Need help?
General
