5
WARNING:
Always SHUT OFF power source to connect power wire.
Any exceeded input voltage will not make this unit function and may
damage this unit.
Grounding Column
The switch already comes with lightning protection mechanism. You can also
ground the switch through the PE (Protecting Earth) with Ground Cable.
Installation of the Switch
This part describes how to install your Ethernet Switch and make
connections to it. Please follow the following instructions to avoid
incorrect installation causing device damage and security threat.
Before cleaning the switch, unplug the power plug of the switch first.
Do not clean the switch with wet cloth or liquid;
Do not place the switch near water or any damp area. Prevent water
or moisture from entering the switch chassis;
Do not place the switch on an unstable case or desk. The switch
might be damaged severely in case of a fall;
Ensure proper ventilation of the equipment room and keep the
ventilation vents of the switch free of obstruction;
Make sure that the operating voltage is the same one labeled
on the switch;
Do not open the chassis while the switch is operating or when
electrical hazards are present to avoid electrical shocks.
To Next Page
Loading...
Need help?
General
