Driver Installation
Please follow the following instructions to install your new wireless USB
Adapter:
1. Insert the USB wireless network card into an empty USB 2.0 port
of your computer, when computer is switched on. Never use force to insert
the card, if you feel it’s stuck, flip the card over and try again.
2. The following message will appear on your computer, click ‘Cancel / Close’.
Windows 7/8/10
3. Insert the driver CD into your CD-ROM. You can see auto run
screen below. If not, you can double click ‘autorun.exe’ on CD.
Click ‘Install Driver’ to start the installation procedure
To Next Page
Loading...
Need help?
General
