DIGITUS POE Web Smart Ethernet Switch
6
1.3.4 Front Panel
The front panel of the Switch consists of series of LED indicators and 16 10/100Mbps
RJ-45 ports.
Figure 1 - Front Panel
10/100Mbps RJ-45 ports (1~16):
Designed to connect to the device with a bandwidth of 10Mbps or 100Mbps. Each has a
corresponding 10/100Mbps LED.
Reset:
Keep the device powered on and push a paper clip into the hole. Press down the button for
about 2 seconds. The system restores the factory default settings.
1.3.5 Rear Panel
The rear panel of the Switch contains AC power connector shown as below.
Figure 2 - Rear Panel
AC Power Connector:
Power is supplied through an external AC power adapter. It supports
AC 100 ~ 240V, 50 /
60Hz.
Grounding Terminal:
The Switch already comes with Lightning Protection Mechanism. You can also ground
the Switch through the PE (Protecting Earth) cable of AC cord or with Ground Cable.
To Next Page
Loading...
