Digium, Inc. Page 31
Chapter 2: Card Installation
Software Installation
Digium hardware requires drivers and libraries that are not integrated
with the Linux kernel. Digium hardware is only supported under Linux.
Digium recommends CentOS, Debian, Red Hat, and Ubuntu distributions
of Linux. However, many other distributions are supported by Digium
Technical Support.
Digium’s software, including drivers and application software, may be
obtained from Digium’s download server at:
http://downloads.digium.com
For an introduction to Asterisk, Digium’s telephony software, including
additional information on its configuration, setup, and features, please
refer to:
http://www.asterisk.org
For the latest information on setting up and configuring DAHDI drivers
for your Digium hardware product, please refer to the latest release of this
manual which is available from the product-specific documentation
section at:
http://www.digium.com
To install your Analog 410 Series card, you will need:
Linux 2.6 kernel headers
Development libraries and headers for ncurses
Development libraries and headers for zlib and openssl
Development libraries and headers for newt
GCC and standard software build tools
It is recommended that you use the most recent version of the Asterisk,
DAHDI, and libpri software for the best results. If you have previously
http://ArtTel.ru
To Next Page
Loading...