diLUSSO FS909G5CSD - Page 31

FAULT
POSSIBLE CAUSE
SOLUTION
No spark when gas
control knob is pressed.
No power.
Check if cord is plugged in and switched on.
Check mains circuit breaker.
Loose sparkers cable.
Call authorised representative.
Burner not aligned properly.
Remove and re-fit burner.
Burner not lighting when
spark ignition working.
Gas supply off.
Check gas supply valve.
Burner not aligned properly.
Remove and re-fit burner.
Burner ports blocked.
Remove, clean and replace burner.
Burner goes out when
control knob released.
Flame safeguard not activated.
Re-light, allow more time for flame
safeguard to activate.
Flame safeguard faulty connection or
broken.
Call authorised representative.
Uneven flame pattern or
slight flame lifting.
Burner ports blocked.
Remove, clean and replace burner.
At minimum flame setting
the flame is too high.
Turndown control setting incorrect.
Call authorised representative.
Small flame on High
setting.
Regulator faulty.
Call authorised representative.
Gas supply pressure low.
Call authorised representative.
Incorrect injector fitted.
Call authorised representative.
Blocked injector or gas supply tube.
Call authorised representative.
Incorrect utensil size.
Refer to operating instructions utensil
choice.
Flame too high on High
setting.
Regulator faulty.
Call authorised representative.
Incorrect injector fitted.
Call authorised representative.
Incorrect utensil size.
Refer to operating instructions utensil
choice.
The oven cannot be
powered on
Socket has no power coming to it.
Turn the main switch off. Remove the plug
from the socket and check if the socket has
power coming to it. If there is no power,
contact electrician to check the socket. If
there is power, call authorised
representative to check the oven.
Page 30