Steps
1. Remove the unit from its packaging
2. Plug the unit into a power outlet, a ‘beep beep’ will sound and the unit will be in
standby mode.
3. Press the “On/O” button to turn the unit On.
4. Press the “Fan Speed” button to change the fan speed (low, med, high).
5. The unit defaults in “Normal” mode. Press the mode button to change to Natural
or Sleep Mode.
6. The unit will operate initially on a continual basis. If a set period of operation is
required, please follow “TIMER” instructions on page 5.
7. To activate 360° oscillation, press the oscillation button. To turn o oscillation,
press again.
8. To switch the unit o at any time, press the “On/O” button.
Settings
TIMER
This air circulator comes with an 8 hour timer that allows you to pre-set the unit to
switch o automatically, in intervals of 1, 2, 4 or 8 hours. To operate, simply select the
number of hours ahead you wish the unit to switch o and the respective indicator
lights will illuminate. If you’d like the unit to run continuously, ensure no timer
indicator lights are illuminated.
HORIZONTAL OSCILLATION
Press the oscillation button to activate 360° Horizontal oscillation. Press again to
deactivate.
90° VERTICAL TILT
Tilt the fan head to achieve up to 90° angled oscillation. Ensure the fan is OFF when
adjusting the fan head position.
Operation
Remote Control
The Remote control can be used to operate all
functions.
1. Remove the battery cover at the back of the
remove control
2. Insert the 3V CR2032 battery.
3. Replace the battery cover.
9
To Next Page
Loading...
Need help?
General
