Remove four (4) Phillips
Slide glass to right side of
Pull the front edge of the
up and forward until the rear
tab releases from the ledge
!
IMPORTANT: Only handle
the Log Set Assembly by the
!
NOTE:
Set Log Set Assembly in front
Install the Log Set Assembly
Bed until the rear tab snaps
!
NOTE:
Assembly is installed tightly
Upper Light Bulb Requirements
Do not exceed 15 Watts per
bulb.
To access the upper light bulb
area:
Remove four (4) Phillips
Maintenance
Ledge
Log
Rear
Tab
Front
Figure 8
To Next Page
Loading...
