Why is the flame shuddering in my Dimplex Indoor Fireplace?
If the flame in your Dimplex Indoor Fireplace is shuddering, it might be due to a defective flicker motor (replace it) or defective flame speed control components (replace them).
Why does my Dimplex Indoor Fireplace heater emit an odor?
If your Dimplex Indoor Fireplace is emitting an odor, it is likely normal operation, especially when the heater is initially turned on. This happens as the heater burns off any dust accumulated during manufacturing or operation. However, if the odor persists or seems unusual, it could indicate a defective heater assembly that should be replaced.
How to stop my Dimplex Indoor Fireplace from dimming the lights?
If the lights in the room dim when your Dimplex Indoor Fireplace is on, it's likely that the unit is drawing close to the circuit's current rating. To resolve this, try moving the unit to another outlet or installing it on a dedicated 15 amp circuit.
What to do if my Dimplex Indoor Fireplace does not turn on manually?
If your Dimplex Indoor Fireplace is not turning on manually, there might be several reasons: * Improper operation: Refer to the Operation Section. * No incoming voltage from the electrical wall socket: Check the fuse/breaker panel. * Loose wiring: Check wiring connections. * Defective switch: Replace the switch. * Defective Remote Control Receiver: Replace the Remote Control Receiver and initialize the Remote Control and Receiver.
Why does my Dimplex Indoor Fireplace heater turn off after a few minutes?
If your Dimplex Indoor Fireplace heater is turning off after a couple of minutes, it could be due to a buildup of dirt or dust in the heater assembly. Make sure the exterior intake louvers and firebox cavity are free of dirt and dust. Alternatively, the heater assembly itself may be defective and require replacement.
Why is my Dimplex Indoor Fireplace control panel buzzing?
If you're hearing a buzzing noise from the control panel of your Dimplex Indoor Fireplace, it's likely due to a defective flame speed controller. Consider replacing the flame speed controller to resolve this issue.
Why is my Dimplex Indoor Fireplace making excessive noise when the heater is on?
If your Dimplex Indoor Fireplace is making excessive noise with the heater on, it could be due to a dirty heater assembly. Ensure that the exterior intake louvers and firebox cavity are free of dirt and dust. If the noise persists, the heater assembly may be defective and need to be replaced.
Why is light leaking around the log set in my Dimplex Indoor Fireplace?
If you notice light leaking around the log set of your Dimplex Indoor Fireplace, it's likely that the log set is not positioned properly. Check the log set for proper fit to resolve this issue.
Why is the flame frozen on my Dimplex Indoor Fireplace?
If the flame in your Dimplex Indoor Fireplace is frozen, it could be due to: * A defective flicker motor: Replace the flicker motor. * A defective flame speed control: Replace the flame speed control components. * Loose wiring: Check the wiring connections.
Why won't my Dimplex Indoor Fireplace heater turn off?
If your Dimplex Indoor Fireplace heater is not turning off, consider the following: * Improper operation: Refer to Operation Section. * Defective Thermostat: Replace Thermostat. * Defective Remote Control Receiver: Replace Remote Control Receiver.
General| Model | DF2690 |
|---|---|
| Type | Electric Fireplace |
| Heating Capacity | Up to 400 sq. ft. |
| Voltage | 120V |
| Heater | Yes |
| Flame Effect | Yes |
| Adjustable Thermostat | Yes |
| Remote Control | Yes |
| Fuel Type | Electric |
| Color | Black |
| Power Consumption | 1500 Watts |
To Next Page
