12 www.dimplex.com
re-initializing after turning the
power off.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call Dim-
plex North America Limited at
1-888-346-7539 for technical
support. Please have your
model and serial number
ready when calling.
Remote Control
The replace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the replace and can pass
through most obstacles (including
walls). It is supplied with one of
Operation
not change just the amount of
heat being emitted.
F. 3-Position Switch
Pressing the switch up "I" toggles
sequentially through the three lev-
els of the replace.
Level 1: The ame effect is
turned on and the rst red indica-
tor light ashes momentarily.
Level 2: The ame effect remains
on, the heater is activated to the
low heat setting, and the rst and
second red indicator lights ash
momentarily.
Level 3: The ame effect remains
on, the heater is set to the high
heat setting, and all three red indi-
cators ash momentarily.
Pressing the switch down "II" will
turn the unit Off.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
replace off and it will not come
back on without being reset. It
can be reset by switching the On/
Off Switch to Off and waiting ve
minutes before switching the unit
back on.
If operating the unit with a remote
control, the remote may require
Figure 6
Off
Button
On
Button
Battery
cover
Plastic
strip
To Next Page
Loading...
