Operation
brightness of the up lights.
D. Flame Speed
Press the F button ( ) to turn the
Flame/Heat on.
Press the L button to increase the
speed of the ame.
Press the K to decrease the
speed of the ame.
E. Sleep Timer
The Sleep Timer automatically
shuts off the Log Grate after a
preset time (from 30 minutes to 8
hours).
Press the F button (
) to turn the
Log Grate on.
To set the sleep timer press the N
button.
Set the timer from 30 minutes
through 8 hours. The Log Grate
will automatically turn off when
the sleep timer reaches zero (0)
minutes.
The Sleep Timer can be cancelled
at any time by pressing the M
button repeatedly until the sleep
timer displays nothing.
WARNING: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of re, electric
shock or damage to persons.
F. Flame & Heat On/Off Button
Press the F button (
) to turn the
Flame/Heat function on. When
B is higher then A the heat will
come on. To turn the heat off,
lower the B so that it’s setting
is lower then the A. The default
temperature setting is 72°F
(22°C).
!
NOTE: When using the
remote control the heater runs
on a thermostat. Press the H
or G buttons to adjust the set
temperature. Once the desired
set temperature is reached
the heater will turn off. The
heater will cycle on and off
to maintain the desired set
temperature.
Child Lock (Figure 2)
Depress tab on the battery 1.
cover on the back of the
remote control and remove
the battery cover.
Move 2. Child Lock tab to
the right to lock the remote
control.
Move 3. Child Lock tab back to
the left to unlock the remote
control.
Replace the battery cover.4.
!
NOTE: To temporarily unlock
the remote control press (in order)
To Next Page
Loading...
Need help?
General
