Hook and
Loop Pads
Wire Connectors
3
Log Grate Assembly
Each log is a separate component
that needs to be placed on the
grate. Position each log so that
the hook and loop pad on the
backside of the log lines up with
the corresponding hook and loop
pad on the log grate. These pads
assist with securing the logs to
the grate.
!
NOTE: Each of these logs
are hand made, and as such, the
hook and loop pads on the logs
and grate may not align perfectly,
therefore, we have included
additional pads should you need
to re-position them.
Each of the logs contain LED
lights to create a ickering effect.
During assembly, each log
requires the electrical connectors
on the log and grate to be
connected as they are being
placed. In some cases, these
wires can have tie wraps added to
prevent the wires from being seen
after nal assembly, not included.
To Next Page
Loading...
