Log Grate Installation
Fill and install the Rell 1.
Container.
CAUTION: It is strongly
recommended that Distilled water
or softened water be used in
the unit to prevent scaling of the
components.
!
NOTE: During initial
installation, the Rell Container
should be relled after the
Reservoir has lled to ensure the
maximum operating time.
Make sure the On/Off switch 2.
is switched to Off (refer to
Operating Instruction section).
Assemble power adapter. 3.
(Figure 2) Plug the power
adapter into the front of the
unit, then plug the unit into a
15 Amp/ 120 volt outlet.
WARNING: Only use Dimplex
approved 24V DC power supply,
min. 2.7A.
The addition of a mesh spark
screen in front of the Log Grate
and Fireplace tools can be used
to complete the look of your
hearth. (Not Included)
!
NOTE: If you need to move
the unit ensure that all of the
components that contain water
have been emptied before
relocating. See Maintenance
Instructions for disassembly.
Figure 2