WARNING: Disconnect power
before attempting any main-
tenance or cleaning to reduce
the risk of re, electric shock
or damage to persons.
Log Grate Surface Cleaning
Use a warm damp cloth only to
clean surfaces of the Log Grate.
Do not use abrasive cleaners.
Water Reservoir
!
NOTE: There is no need to
remove any of the logs or move
the unit to access the water
storage system. However if
you decide to move the unit to
perform cleaning ensure that the
logs are stable before moving.
The water storage system is lo-
cated behind the back log. It can
easily be removed by lifting each
of the components directly up.
(Figure 5)
!
NOTE: There are tabs, on
each end, that need to be turned
to release the components.
CAUTION: It is strongly
recommended that Distilled water
or softened water be used in
the unit to prevent scaling of the
components.
If you do not intend on using
the unit for longer than 2 weeks,
Maintenance
empty and drain the unit of water,
and dry all of the water containing
components.
It is recommended that all of the
water containing components are
cleaned with soap and water on
a biweekly basis. A small brush
has been included to assist in
cleaning difcult items/areas, i.e.
the transducer.
CAUTION: Do not put plastic
components in the dishwasher.
!
NOTE: If you need to move
the unit ensure that all of the
components that contain water
have been emptied before
relocating.
Figure 5
To Next Page
Loading...
Need help?
General
