Operation
The manual controls for the Log
Grate are located in the front right
side. (Figure 3)
A. On/Off Switch
Supplies power to the Log Grate.
B. Momentary Button
Pressing this button toggles
between Logs; Logs and Flame
Effect; and Off.
Remote Control
The unit is supplied with a radio
frequency remote control. This
remote control has a range of
approximately 50' (15.25m).
It does not have to be pointed
at the replace and can pass
through most obstacles (including
walls). It is supplied with one of
243 independent frequencies to
prevent interference with other
units. The frequency designation
is indicated on the back of the
remote control.
!
NOTE: Before attempting any
operation with the remote control,
pull the plastic insulator strip out
from between the remote casing
and battery cover (Figure 4).
Remote Control Initialization/
Reprogramming
Follow these steps for remote
control initialization and if
required, re-initialization:
Unplug power adapter from 1.
unit.
Wait a minimum of ve (5) 2.
Figure 3
B
A
To Next Page
Loading...
Need help?
General
