Site Selection and Preparation
Figure 1
Transducer
Wire Slots
Emitter
Unpack the transducer 4.
(contained within the water
reservoir) which has been
wrapped to protect it during
shipping. See Figure 1.
To access the transducer:
Remove top cover by turning •
the retaining tabs on both
ends of the water reservoir.
Remove any packing •
material.
Install transducer so that it •
is sitting level in the circular
holding area in the Reservoir.
Retaining
Tabs
Removable Rell
Container
Water
Reservoir
Orient transducer wire so that •
it does not sit directly above
the Emitter and the wire
passes through the slot in the
side of the tank.
Reinstall the top cover and •
ensure both retaining tabs
have been turned so that
they are pointing inwards.
!
NOTE: Completely assemble
the unit before lling with water.
Top Cover
To Next Page
Loading...
