Maintenance
Replacement:
① Unplug the unit from power
outlet.
② On the back of the stove,
remove the three (3) screws from
the light access cover (Figure 2).
Figure 2
Screw locations
Light
access
cover
Light bulb
③ Remove the light access
cover.
④ Reach into the opening
and unscrew the bulb counter
clockwise.
⑤ Insert new bulb.
⑥ Install the light access cover
and install the screws.
Glass Cleaning
The glass is cleaned in the factory
during the assembly operation.
During shipment, installation,
handling, etc., the front glass
panel may collect dust particles;
these can be removed by dusting
lightly with a clean dry cloth.
To remove ngerprints or other
marks, the front glass panel can
be cleaned with a damp cloth.
The front glass panel should be
completely dried with a lint free
cloth to prevent water spots. To
prevent scratching, do not use
abrasive cleaners or spray liquids
on the glass surface.
Surface Cleaning
Use warm water only to clean
painted surfaces of the stove. Do
not use abrasive cleaners.
Servicing
Except for light bulb replacement
and cleaning described above, an
authorized service representative
should perform any other
servicing.
To Next Page
Loading...
Need help?
General
