Dimplex DXRCF - LED Display and Operational Warnings; LED Display Light Indication

LED Display Light Indication
A - Product Disconnected from Charging Port – No USB cable connection:
1. When the appliance is o󰀨 - all the display LED lights are o󰀨.
2. When the appliance is on and the battery is fully charged, the working
indication of the LED lights are as follows:
• Quiet Speed: Light 1 on, Light 2, 3 & 4 o󰀨
• Low Speed: Light 1 & 2 on, Light 3 & 4 o󰀨
• Medium Speed: Light 1, 2 & 3 on, Light 4 o󰀨
• High Speed: Light 1, 2, 3 & 4 on.
3. When the battery has too low a charge and you try to switch it on the LED
lights will ash 5 times (quick ash on & o󰀨 - interval 0.25 seconds) then turn o󰀨
completely.
4. When the appliance has been running and the charge in the battery runs too
low then the working indication of the LED lights will ash depending on which
speed mode was operating as follows;
• If the appliance is working on Quiet speed (light 1 on), then light 1 will ash 5
times and the product & light will switch o󰀨.
• If the appliance is working on Low speed (lights 1 & 2 on), then lights 1 & 2
will ash 5 times and the product & lights will switch o󰀨.
• If the appliance is working on Medium speed (lights 1, 2 & 3 on), then lights 1,
2 & 3 will ash 5 times and the product & lights will switch o󰀨.
• If the appliance is working on High speed (lights 1, 2, 3 & 4 on), then lights 1,
2, 3 & 4 will ash 5 times and the product & lights will switch o󰀨.
5. When the appliance has charge in the battery and it is not operating (in o󰀨
mode) you can check the battery power by pressing and holding the button for
1.5 seconds or more, the LED lights will indicate the battery power with LED
indication as follows:
• When battery power is lower than 25%, Light 1 will light.
• When battery power is between 25% and 50%, Lights 1 & 2 will light.
• When battery power is between 50% and 75%, Lights 1, 2 & 3 will light.
• When battery power is between 75% and 100%, Lights 1, 2, 3 & 4 will light.
B - Product Connected to A Live Charging Port Via the USB Cable:
1- Charging Mode - See ‘Charging Mode’ section earlier in this booklet for
description of LED indication of power/charge in the battery when charging and
fully charged.
2 – Normal Operating mode while connected – See ‘Short Press Operation
sequence’ section on the opposite page with description of LED indication in
di󰀨erent operating modes.