EN-6 452172.66.05-EN · FD 0306 www.dimplex.de
English LIA 0608HXCF M - LIA 1316HXCF M
4 Transport and storage
During transport and storage, the unit must be kept in a dry
place and must not be exposed to temperatures below freez-
ing.
When storing the unit, care should be taken to ensure that no
other gases, liquids or solids can enter the unit. The connec-
tions of the unit should remain closed until the unit is finally in-
stalled. Furthermore, care must be taken to ensure that no
damage can occur to the unit or individual components during
the transport and storage of the unit. Please make sure that the
unit is not stacked (no load from above on the unit) or crushed.
When storing the unit, make sure that it is stored in a room with
a sufficiently large space (especially when storing in base-
ments, garages, conservatories, etc.).
!
Refer to the product packaging labels for storage and
transport information.
!
The unit must be stored in a well ventilated room where there
is no continuously present ignition source (example: naked
flames, gas-powered household appliance, electrically-
powered heating device, workshops).
!
The unit must be stored in a well ventilated room where the
room size corresponds to the intended room area for
operation. (see cap. 5.3.4)
4.1 Removing transport fastening
(depending on the device)
After transportation, the transport fastening in the device is to
be removed from the base.
!
Please ensure that the transport fastening has been removed.
It causes unusual vibrations and noises at the heat pump if it is
operated with the transport fastening for the compressor in-
stalled.
Remove
transport lock
LIA 1316HXCF
LIA 1316HXCF M
To Next Page
