EasyManua.ls Logo

Dimplex Opti-Myst Cassette 500 - User Manual

Dimplex Opti-Myst Cassette 500
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
CAS1000
The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC)
EN55014, EN60555-2 and EN60555-3 These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC
08/52890/0 Issue 1
CAS500

Questions and Answers

  • N
    Nancy RandallSep 23, 2025
    Why does my Dimplex Indoor Fireplace have an unpleasant smell?
    • J
      Jamie BarnettSep 23, 2025
      If there's an unpleasant smell when your Dimplex Indoor Fireplace is in use, it could be due to dirty or stale water, or using unfiltered tap water. Clean the unit as described under maintenance and only use filtered tap water.
  • M
    Michael JohnsonAug 25, 2025
    Why is the flame effect too low on my Dimplex Opti-Myst Cassette 500 Indoor Fireplace?
    • V
      Victoria HallAug 25, 2025
      If the flame effect on your Dimplex Indoor Fireplace is too low, consider these potential causes: 1. The flame effect control knob might be set too low. Try increasing the flame level using your remote or receiver. 2. The disc in the transducer could be dirty. Clean the disc with a soft brush. 3. The wire from the Transducer Unit might be sitting over the disc. Direct the wire to the back of the sump, ensuring it sits in the side slot exiting the sump.
  • R
    Rachael DixonAug 25, 2025
    What to do if my Dimplex Opti-Myst Cassette 500 Indoor Fireplace smells unpleasant when used?
    • J
      justinturnerAug 26, 2025
      If your Dimplex Indoor Fireplace emits an unpleasant smell during use, it could be due to: * Dirty or stale water. Clean the unit. * Using unfiltered tap water. Switch to using only filtered tap water.
  • C
    Connor Knight MDAug 27, 2025
    Why does my Dimplex Opti-Myst Cassette 500 flame effect have too much smoke?
    • L
      Leroy SantosAug 27, 2025
      If the flame effect on your Dimplex Indoor Fireplace is producing too much smoke, the flame effect setting may be too high. Try turning down the flame effect and allow some time for the flame generator to adjust to the new setting.
  • D
    darrylpayneAug 27, 2025
    How to fix Dimplex Indoor Fireplace with little or no mist?
    • H
      hicksjessicaAug 27, 2025
      If your Dimplex Indoor Fireplace produces little or no mist, several factors could be responsible. First, check the transducer's operation and clean it and the sump thoroughly. Ensure the transducer sits correctly in the sump. Also, remove and clean the air filter, making sure to place it back correctly. Finally, ensure the nozzle is correctly positioned on the sump and clean the sump, transducer, and nozzle thoroughly to resolve any blockages.
  • K
    Kaylee TaylorSep 15, 2025
    What to do if Dimplex Opti-Myst Cassette 500 Indoor Fireplace won't operate and LEDs blink twice?
    • M
      Mike RowlandSep 15, 2025
      If your Dimplex Indoor Fireplace will not operate and the LEDs are continuously blinking twice, it means the product has no water. If your product uses water bottles, refill them. If it's connected to mains water, check the water supply at the inlet of the product.
  • C
    chadshieldsSep 12, 2025
    How to fix Dimplex Opti-Myst Cassette 500 flame effect not starting?
    • K
      kevinmartinSep 13, 2025
      If the flame effect on your Dimplex Indoor Fireplace won't start, make sure the mains plug is correctly plugged into the wall socket. Also, verify that the water tank is full and there is water in the sump. Check the low voltage connector to ensure it's properly connected.
  • A
    amymartinSep 14, 2025
    What to do if Dimplex Opti-Myst Cassette 500 Indoor Fireplace stopped, and the LEDs are blinking twice?
    • S
      Samantha TurnerSep 14, 2025
      If your Dimplex Indoor Fireplace has stopped working and the LEDs are blinking twice, it means the product has run out of water. If your product uses a water bottle, lift off the fuel bed, switch the product off, refill the bottle, replace it, and switch the product back on, then turn the product back on. If connected to mains water, switch the product off, check for leaks in the tubes, and ensure the ball valve is open. Once the mains water supply is restored, turn the product back on.
  • B
    Brittany MeyerSep 5, 2025
    Why does my Dimplex Indoor Fireplace remote control stop working?
    • S
      Spencer NguyenSep 5, 2025
      If your Dimplex Indoor Fireplace remote control stops working, it could be due to a few reasons. It might be a Bluetooth range issue, a loose connection with the Bluetooth Receiver, or the remote control batteries may need replacing. Try these solutions: * Check the positioning of the Bluetooth Receiver, ensuring it's not encased in metal or concrete. * Check the connection to the jack. * Replace the batteries with two new AAA batteries.
  • M
    Marc MeyerSep 3, 2025
    What to do if Dimplex Indoor Fireplace LEDs blink once every 8 seconds?
    • N
      nicholas50Sep 3, 2025
      If the LEDs on your Dimplex Indoor Fireplace continuously blink once every 8 seconds on one side, it indicates overflow detection on that side. Switch off the product and the water supply, then contact your dealer for assistance.

Dimplex Opti-Myst Cassette 500 Specifications

General IconGeneral
Product NameDimplex Opti-Myst Cassette 500
CategoryIndoor Fireplace
StyleModern
TechnologyOpti-Myst
InstallationBuilt-in
Remote ControlYes
Fuel TypeElectric
Water Tank Capacity1.5 liters
Runtime per Tank8 hours
TypeElectric Fireplace
Flame EffectRealistic 3D Flame Effect
Weight15 kg
Power Supply230V, 50Hz
Log Set/Bed OptionsIncluded

Related product manuals