EasyManua.ls Logo

Dimplex SCxn175sd - User Manual

Dimplex SCxn175sd
28 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Page 1 of 28
ST0109 – C 05/09
WATER
Unvented hot water cylinder – SCxn…d/i, SCxn…sd/si
Installation and operating instructions

Table of Contents

Questions and Answers

  • J
    juliereynoldsAug 8, 2025
    Why is there no hot water from my Dimplex Water Heater?
    • C
      Cindy SanchezAug 8, 2025
      Several factors could be the reason for no hot water. It could be due to the timer/programmer not being set correctly, so ensure that it is properly configured. Another reason may be a malfunction in the auxiliary heating, in which case you should consult the auxiliary heating system instructions. There might be a direct heating malfunction, so call a qualified person to check the immersion heater. It's also possible that the auxiliary/direct heating high limit thermostat has tripped; in this case, reset the limit thermostat(s).
  • A
    Adrienne YorkAug 13, 2025
    What to do if there is no water from hot water taps of Dimplex Water Heater?
    • B
      brittanylawrenceAug 13, 2025
      If there's no water coming from the hot water taps, the stop valve might be closed, so open it. Another potential issue is a blocked strainer, in which case you should turn off the water supply, clean the strainer, and then re-commission the system. Also, check if the pressure reducing valve is fitted against the flow; if so, re-fit it with the arrow showing in the direction of the flow.
  • B
    Brad LiuAug 17, 2025
    Why Dimplex Water Heater has continuous discharge?
    • R
      Richard RamirezAug 17, 2025
      A continuous discharge could be due to a pressure reducing valve not working correctly; check the pressure after the valve and replace it if it's faulty. It may also be that the pressure relief or T&P valve isn't seating correctly; manually lift the valve once or twice to clear any debris, and if that doesn't work, replace it. Lastly, it could be a malfunction of the high limit thermostat or appliance, so check the function of the thermostats and appliances.
  • C
    Cynthia EllisAug 21, 2025
    What to do if Dimplex Water Heater has intermittent water discharge through tundish on warm-up?
    • K
      Kurt StewartAug 21, 2025
      An intermittent water discharge through the tundish during warm-up could mean the bubble is depleted. Refer to the commissioning instructions for creating a bubble. Alternatively, the expansion vessel might have lost its charge; check the expansion vessel (see commissioning/maintenance), and top it up or replace it as needed.
  • C
    Christopher DunnAug 26, 2025
    Why is there hot water from the cold tap of Dimplex SCxn175sd?
    • J
      jason25Aug 26, 2025
      If you're getting hot water from the cold tap, it could be because the hot pipe work is routed adjacent to the cold pipe work; in this case, insulate the hot pipe work or re-route it. Another possibility is a leaking seal in the mixer tap, so replace the seals in the mixer tap.
  • M
    Monica EdwardsAug 30, 2025
    How to fix leakage from casing of Dimplex Water Heater?
    • B
      Barbara SantosAug 30, 2025
      Leakage from the casing may be due to compression/threaded joints not formed correctly. Re-seal the joints with care.
  • V
    Vanessa LyonsSep 3, 2025
    How to eliminate metallic noise from Dimplex SCxn175sd Water Heater system?
    • K
      Kyle MillerSep 3, 2025
      A metallic noise from the system might indicate that the pipe work is not sufficiently supported. Try adding extra pipe work fixings.

Dimplex SCxn175sd Specifications

General IconGeneral
BrandDimplex
ModelSCxn175sd
CategoryWater Heater
LanguageEnglish

Related product manuals