37
730.138 | 08.12
EN
7.3 Functions
Additional controller settings can be made by using the "Functions" sub-
menu.
The following submenus can be opened using the "Functions" menu item:
Circulation 7.3.2
Back-up heating 7.3.3
Solid fuel boiler 7.3.4
Quick charge 7.3.5
Heat quantity 7.3.6
Thermostat 7.3.7
Difference thermostat 7.3.8
Time function 7.3.9
Interval 7.3.10
Stagnation reduction 7.3.11
Holiday function / recooling 7.3.12
Frost protection 7.3.13
Display storage tank top 7.3.14
Alarm output 7.3.15
An overview of the factory settings and the ranges of possible settings
can be found in the table in chapter 14.3 "Parameter values for func-
tions".
7.3.1 Accessing a function
Before making settings within a function, you must perform the follow-
ing steps:
Selecting a function
SET: press button for approx. 2 sec.
: select the menu item "Functions".
SET: open the submenu "Functions".
: select a function.
Activating/deactivating a function
SET: press button.
The display for activating (on) or deactivating (off) the function
is shown.
SET: press button for approx. 2 sec.
The function is activated or deactivated.
NOTE
An information window is displayed if the function cannot be activated
(see chapter 11 "Information windows").
Selecting an output
: press button.
The display for setting the output appears.
SET: press button.
Output (?) flashes.
: choose the desired output.
SET: press button to confirm.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
