EasyManua.ls Logo

Dimplex XL24N - User Manual

Dimplex XL24N
9 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ContactDetails
Pleasenotethatsomeofthecontactdetailson
thisPDFdocumentmaynotbecurrent.
Pleaseusethefollowingdetailsifyouneedto
contactus:
Telephone:08448793588
Email:customer.services@gdcgroup.co.uk
Thecustomersupportsectionofourwebsitealsofeaturesawide
rangeofinformationwhichmaybeofusetoyouandisavailable
24hoursaday.Itincludes:
• Operatingandinstallationinstructions
• Easy‘Howtouse’guidesforstorageheaters
• Serviceandrepairs
• Where
tobuyourproducts
• Literaturedownloads
• Heatingrequirementcalculator
Visit‐www.dimplex.co.uk/support
A division of GDC Group Ltd
Millbrook House Grange Drive Hedge End Southampton SO30 2DF
www.dimplex.co.uk
Re
g
istered No: 1313016 En
g
land
VAT GB 287 1315 50004
EEE Producer Registration Number –
WEE/GE0057TS
Paper from sustainable sources

Table of Contents

Other manuals for Dimplex XL24N

Preview: Installation Instructions
Installation Instructions8 pages

Questions and Answers

  • F
    Fred BlackAug 8, 2025
    Why is my Dimplex XL24N Heater too cold?
    • R
      Ryan RangelAug 8, 2025
      If your Dimplex heater is too cold, it could be due to a few reasons. There might have been a power interruption affecting the charge, so check the off-peak circuit, wall switch, fuse, and consumer unit. Also, if you have an automatic (XLS) heater and the room is already warm, it won't take an unnecessary charge. In this case, turn the INPUT control down. You can also try turning up the INPUT control, but note that this may take up to 24 hours to take effect.
  • B
    Bryan MartinAug 14, 2025
    How to make my Dimplex Heater warmer in the evening?
    • K
      Kristin DanielsAug 14, 2025
      To make your Dimplex heater warmer in the evening, set the OUTPUT control to minimum and then turn it to maximum when you want more heat. Remember to return it to minimum before you go to bed so that the heater can take a full charge.
  • J
    Jeremy BerryAug 19, 2025
    Why is one of my Dimplex Heaters colder than the other?
    • G
      guy94Aug 19, 2025
      If you have two automatic (XLS) Dimplex heaters in one area, they might be affecting each other. To resolve this, set one heater higher as a primary heat source and the other lower to provide supporting heat. This will prevent them from cancelling each other out and taking a reduced charge.
  • E
    ericeAug 26, 2025
    What to do if my Dimplex XL24N is too hot?
    • J
      jonesgaryAug 26, 2025
      If your Dimplex heater is too hot, turn the INPUT control down and the OUTPUT control to minimum. Keep in mind that these adjustments may take up to 24 hours to take effect.
  • C
    Cynthia HernandezSep 1, 2025
    Why does my Dimplex XL24N Heater smell?
    • R
      Raymond ArmstrongSep 1, 2025
      Apart from the initial commissioning period or dust accumulation after inactivity, your Dimplex heater should not emit smells. If decorating is planned, turn off the storage heater and ensure the room is well-ventilated before turning it back on. Soot deposits from lit cigarettes, candles, and oil burners, combined with the convection effect of the heater, can also cause smells. Installing a shelf above the heater, with at least 250mm clearance, can divert heat and prevent soot buildup on the wall.

Summary

Contact Details

Operating Instructions

Setting Up Your New Heater

Initial setup and commissioning process for the heater, including important safety warnings.

Benefits of Storage Heating

Explains the advantages and operational principles of storage heating technology.

Know Your Heater

Details how off-peak electricity is used to charge the heater and store heat for later use.

Heater Controls and Operation

Setting Up Heater for Normal Use

Guidance on adjusting the INPUT control for optimal heating based on model type and conditions.

INPUT Energy Control

Explains the function of the INPUT control for managing off-peak electricity charge and stored heat.

Setting the INPUT Control

Step-by-step instructions and diagrams for adjusting the INPUT control for comfort.

Output Boost Heating

Manual BOOST Operation

How to manually control heat release using the OUTPUT control for faster heat or boost.

Automatic BOOST Operation

How the OUTPUT control settings trigger automatic heat release based on time of day.

Commercial Use

Specific OUTPUT control setting for commercial environments with fixed operating hours.

Seasonal Settings and Holidays

Summer Settings

Instructions for switching the heater off during summer months and turning it back on.

Preparing for Colder Weather

Guidance on turning the heater on, allowing charge time, and adjusting controls for winter.

Holidays - Summer and Winter

Advice on how to set the heater during summer holidays and winter to protect from frost.

Troubleshooting Guide

My Heater is Too Cold

Troubleshooting steps for a heater not providing enough heat, checking power and controls.

My Heater is Too Hot

Steps to address a heater that is too hot, focusing on INPUT and OUTPUT controls.

Heater Smells or Wall Marks

Addresses unusual smells, wall discoloration, and causes like dust or decorating fumes.

After Sales Service and Support

Cleaning and Maintenance

Instructions for cleaning the heater's external appearance and advice on wall discoloration.

After Sales Service

Information on product guarantee, obtaining support, and required details for service.

Spare Parts and Protective Guards

Guidance on sourcing spare parts and ordering protective guards for the storage heaters.

Dimplex XL24N Specifications

General IconGeneral
BrandDimplex
ModelXL24N
CategoryHeater
LanguageEnglish

Related product manuals