7 Wipe the surface of the new filter cartridge
and the opposite side of the filter head to
remove dirt.
8 Slightly dampen the surfaces of the filter
cartridge with fuel and re-screw the filter
head clockwise (17-18 Nm).
9 Fit the drainage cap by applying a
tightening torque of 3.5～4Nm.
10 Connect the cables.
11 Open the fuel cock and bleed the system.
D-4 Engine radiator - Cleaning
To remove dust and debris from the radiator
mass, compressed air, pressurised water or
steam can be used. However, it is preferable
to use compressed air.
When using pressurised water, keep the
high pressure jet cleaning nozzles at a
distance of at least 50cm from the radiator
mass. Bringing the nozzle too close to the
radiator mass can lead to risk of damaging
the radiator.
To Next Page
Loading...
