Maintenance
D-3 Fuel pre-filter - replacement
Fuel is flammable and can cause severe
burns and death.
Do not smoke or use naked flames while
working on the fuel line.
Clean the engine parts and engine
compartment to remove all traces of fuel to
prevent risk of fire.
Deutz Fuel pre-filter replacement
(1) Pump fuel supply
(2) Bleed screw
(3) Electric connection for the
water level sensor
(4) Drainage cap
(5) Filter cartridge
(6) Fuel tank inlet
1 Stop the engine.
2 Block the fuel intake to the engine (if the
tank is positioned at the top).
3 Place a suitable container.
4 Disconnect the cables.
5 Slacken the drainage cap and drain out
the liquid.
6 Remove the filter element.
7 Wipe the surface of the new filter cartridge
and the opposite side of the filter head to
remove dirt.
8 Slightly dampen the surfaces of the filter
cartridge with fuel and re-screw the filter
head clockwise (17-18 Nm).
9 Fit the drainage cap by applying a
tightening torque of 1.6±0.3Nm.
10 Connect the cables.
11 Open the fuel cock and bleed the system.
Parker Fuel pre-filter replacement.
(1) Joystick
(2) Filter cartridge
(3) Pump fuel supply
(4) Fuel tank inlet
(5) Plug
(6) Drainage cap
1 Stop the engine.
2 Block the fuel intake to the engine (if the
tank is positioned at the top).
3 Place a suitable container.
4 Disconnect the cables.
5 Slacken the drainage cap and drain out
the liquid.
6 Remove the filter element.
To Next Page
Loading...
