OPERATOR’S MANUAL with Maintenance Information
Function Tests
25
36 Press the lift function select button. The
indicator light should turn on. Press and
hold the function enable switch on the
control handle. Raise the platform.
⊙ Result: The platform should rise.
37 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch in the
direction identified by the yellow triangle
on the control panel.
⊙ Result: The front wheels should turn in the
direction that the yellow triangle points on
the control panel. Until the steering angle is
less than 30 degrees
38 Lower the platform to the stowed position
39 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch on top of
the proportional control handle in the
direction identified by the yellow triangle
on the control panel.
⊙ Result: The front wheels should turn in the
direction that the yellow triangle points on
the control panel. Until the steering angle is
greater than 30 degrees
40 Press the lift function select button. The
indicator light should turn on. Press and
hold the function enable switch on the
control handle. Raise the platform.
⊙ Result: Raise the platform approximately
3.5 m from the ground and stopped rising.
The alarm should sound
41 Press the drive function select button.
42 Press and hold the function enable switch.
Slowly move the control handle in the
direction indicated by the arrow.
⊙ Result: The drive function should not work
in either direction.
43 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch in the
direction identified by the blue triangle on
the control panel.
⊙ Result: The front wheels should turn in the
direction that the blue triangle points on the
control panel. Until the steering angle is
less than 30 degrees
44 Press and hold the function enable switch.
Slowly move the control handle in the
direction indicated by the arrow.
⊙ Result: The drive function should work
properly.
45 Press the lift function select button. The
indicator light should turn on. Press and
hold the function enable switch on the
control handle. Raise the platform.
⊙ Result: The platform should rise.
46 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch in the
direction identified by the blue triangle on
the control panel.
⊙ Result: The front wheels should turn in the
direction that the blue triangle points on the
control panel. Until the steering angle is
less than 30 degrees
47 Lower the platform to the stowed position
48 Press the drive function select button. The
indicator light should turn on.
49 Push the steer mode select button for
steer FS mode (Rear Steer mode).
50 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch on top of
the proportional control handle in the
direction identified by the blue triangle on
the control panel. Until the steering angle
is greater than 30 degrees.
To Next Page
Loading...
