DINGLI JCPT2212DC - Page 29

OPERATOR’S MANUAL with Maintenance Information
Function Tests
24
19 Pull the red Emergency Stop button out to
the on position.
⊙ Result: The LED indicator light should
come on.
Test the Horn
20 Push the horn button.
⊙ Result: The horn should sound.
Test Up/Down Functions and
Function Enable
21 Do not hold the function enable switch on
the control handle.
22 Slowly move the control handle in the
direction indicated by the blue arrow, then
in the direction indicated by the yellow
arrow.
⊙ Result: No functions should operate.
23 Press the lift function select button.
24 Press and hold the function enable switch
on the control handle.
25 Slowly move the control handle in the
direction indicated by the blue arrow.
⊙ Result: The platform should raise.
26 Release the control handle.
⊙ Result: The platform should stop raising.
27 Press and hold the function enable switch.
Slowly move the control handle in the
direction indicated by the yellow arrow.
⊙ Result: The platform should lower. The
descent alarm should sound while the
platform is lowering.
Test the Steering
Note: When performing the steer and drive
function test, stand in the platform facing the
steer end of the machine.
28 Press the drive function select button. The
indicator light should turn on.
29 Push the steer mode select button for
steer FS mode (Front Steer mode).
30 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch on top of
the proportional control handle in the
direction identified by the blue triangle on
the control panel.
⊙ Result: The front wheels should turn in the
direction that the blue triangle points on the
control panel. Until the steering angle is
greater than 30 degrees.
31 Press the lift function select button. The
indicator light should turn on. Press and
hold the function enable switch on the
control handle. Raise the platform.
⊙ Result: Raise the platform approximately
3.5 m from the ground and stopped rising.
The alarm should sound
32 Press the drive function select button.
33 Press and hold the function enable switch.
Slowly move the control handle in the
direction indicated by the arrow.
⊙ Result: The drive function should not work
in either direction.
34 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch in the
direction identified by the yellow triangle
on the control panel.
⊙ Result: The front wheels should turn in the
direction that the yellow triangle points on
the control panel. Until the steering angle is
less than 30 degrees
35 Press and hold the function enable switch.
Slowly move the control handle in the
direction indicated by the arrow.
⊙ Result: The drive function should work
properly.