DINGLI SL1323-AWD - Page 36

OPERATOR’S MANUAL with Maintenance Information
Operating Instructions
32
At the Platform Controls
Press the lift function select button.
Push and hold the function enable switch.
Activate the control handle in the direction
indicated by the yellow arrow.
Operation from Ground with
Controller
Maintain safe distances between operator,
machine and fixed objects.
Be aware of the direction the machine will
travel when using the controller.
Outrigger Operation (if
equipped)
1 Position the machine below the desired
work area.
Note: The engine must be running for the
outriggers to operate.
2 Push and hold the auto level button.
3 Press and hold the function enable switch.
Activate the proportional control handle in
the direction indicated by the yellow arrow.
The outriggers will extend and level the
machine. A beep will sound when the
machine is level.
The indicator light on the lift function enable
button will turn on when one but not all
outriggers are down. All drive and lift functions
are disabled.
The indicator lights on the lift function enable
button and on the individual outrigger buttons
will turn off when all the outriggers are in firm
contact with the ground.
The drive function is disabled while the
outriggers are down.
To control individual outrigger
1 Push and hold one or more outrigger
buttons.
2 Press and hold the function enable switch.
Activate the proportional control handle in
the direction indicated by the yellow arrow.
The outriggers will extend and level the
machine.
Outrigger Auxiliary Retract
1 The platform must be in the lowest height.
Operation the machine on the ground
control.
2 Press and hold the lift function enable
button. Press and hold the platform down
button. Press and hold the overload
indicator button.
How to use the Safety Arm
1 Raise the platform approximately 5.5 m
from the ground.
2 Release the safety arm latch, lift the safety
arm and rotate up to a vertical position.
Lock the safety arm in position.
Note: Be sure that the safety arm is locked in
the vertical position.
3 Lower the platform until the safety arm
rests securely on the link.
Crushing hazard. Keep hand
clear of the safety arm when lowering the
platform.
Don’t engage the safety arm
unless unload the platform.
After Each Use
1 Select a safe parking location - firm level
surface, clear of obstructions and traffic.
2 Lower the platform.