③ Insert grounding body (iron rod with a diameter of 5 ~ 10mm) 200mm
below into the earth and lead it out with conductor;
④ Connect the other end of the grounding wire reliable to the led wire of
grounding body.
（4）Battery charging
Tip:
• Rated DC voltage of this generator is 12V;
• After the generator is started up, connect the battery to the generator;
• Before charging, make sure that DC protector has been switched on.
① Start up the generator.
② Connect red conductor of the battery to positive (+) terminal of the battery.
③ Connect black conductor of the battery to negative (-) terminal of the battery.
ATTENTION
• Make sure that red conductor of the charger is connected to
positive terminal (+) of the battery, and black wire and negative
terminal shall not be connected reverse.
To Next Page
Loading...
