IX. Storage and Transport
（1）Generator storage
If it is stored long-term, in order to prevent aging, you shall take some storage
measures.
1). Turn the three-in-one switch to "OFF".
2). Open fuel tank cap, to take out fuel filter
screen. Pump all fuel in fuel tank into
special fuel tank, and then reassemble fuel
tank cap back;
3). Start up the engine to burn off fuel in the
carburetor, and then shut it down;
Tip: Do not connect any electrical equipment. Running time of the engine
depends on remaining fuel in the fuel tank.
4). Remove bolts of right enclosure;
5). Unscrew fuel drain bolt on the carburetor, and drain fuel in the carburetor
into special fuel tank.
6). Turn three-in-one switch to "OFF";
7). Tighten fuel drain bolt;
8). Assemble right enclosure back, and tighten bolts;
9). After the engine is completely cooled, switch off ventilation knob of fuel
tank cap;
10). Unscrew oil dipstick, and drain oil in the crankcase off. Fill new oil to
upper oil limit, and then assemble oil dipstick.
11). Remove spark plug, to pour a spoon of clean oil into combustion
chamber. Rotate the crankshaft a few turns, to distribute oil
everywhere, and then reassemble spark plug;
12). Gently pull startup handle until you feel resistance, allowing both inlet
valve and exhaust valve to be closed;
13). Place the generator set in a clean and dry area.
(2)Generator transport
• When the generator set is transported, it shall be ensured that there
is no fuel spilling;
To Next Page
Loading...