connected electrical equipment. AC indicator (green) is off and overload
indicator (red) lights up, but the engine will not stop running.
When overload indicator is on and the generator has no output, please take
following counter measures:
① Switch off electrical equipment connected, and shut down the generator.
② Reduce total power of electrical equipment connected to the range of
rated output.
③ Check whether there is any foreign matter blocking in cooling air inlet,
and whether there is any abnormality in related control components. If there
is any problem, eliminate it immediately.
④ After checking, restart the engine.
Tip: When using electrical equipment with high starting current (such as
compressors, submersible pump, etc.), the overload indicator may start to
light up for a few seconds at the beginning, but this is not the failure
mentioned earlier.
（4） AC indicator (green)
The AC indicator lights when the engine is started and output normally.
（5）DC protection
When electronic equipment connected to DC of the generator is running, if
current is beyond rated current, DC switch automatically switches off to "OFF"
position. When operating the generator again, please press DC switch to "ON"
position.
1） “ON” DC normal outputs.
2） "OFF" DC does not output.
ATTENTION
If DC protection is in off status, reduce the load of
electronic device connected to
rated output range of the generator. If DC
protection is still in off status, please stop using electrical equipment directly
and consult your dealer.
To Next Page
Loading...