Dino-Power DP-X3 - How to Spray

How to Spray
12
How to Spray
Spray Tip Installation
To prevent spray tip leaks make certain
spray tip and tip guard are installed
properly.
1. Perform Pressure Relief
Procedure, page 9.
2. Engage trigger lock.
3. Verify spray tip and tip guard parts
are assembled in the order shown.
a. Use airless spray tip to align
gasket and seal in the tip guard.
b. Spray tip must be pushed all the way
into the tip guard.
c. Turn the arrow shaped handle on
the spray tip forward to the spray
position.
4. Screw spray tip and tip guard assembly
onto the gun and tighten.