Dino-Power DP-X3 - Page 20

18
Storage
3. Turn Prime/Spray valve down
to PRIME position.
4. Turn ON/OFF switch to ON position.
5. Turn pressure control knob
clockwise until the pump turns on.
6. When storage fluid comes out of
drain tube (5-10 seconds) turn
ON/OFF switch to OFF position.
7. Turn Prime/Spray valve horizontal to
SPRAY position to keep storage fluid
in sprayer during storage.
8. Leave gun attached to hose.
9. Remove tip and guard and clean with
water or flushing fluid and a brush.
10. Wipe paint off outside of gun using a
soft cloth moistened with water or flush-
ing fluid.
11. Secure a plastic bag around suction
and drain tube to catch any drips.