· Configure via the user interface on the IP Phone
· Configure via the web interface on your PC
There are two ways to customize the configurations of the IP Phone.
Configure the IP Phone
5
Configure via the user interface on the IP Phone
Network Setting
Account Setting
Active: Press or to select Enable/Disable to enable or disable the account.
Label: It is shown on the LCD screen to identify the account.
Display Name: It is shown as caller ID when you place a call.
Register Name: It is an authenticated ID for authentication provided by ITSP (required).
User Name: It is provided by ITSP for registration (required).
Password: It is provided by ITSP for registration (required).
SIP Server: It is provided by ITSP for registration (required).
SIP Port:It is provided by ITSP for registration (required).
The LCD screen and the keypad on the IP Phone allows you to execute all call
operation tasks and basic configuration changes directly on the phone.
By default, the phone attempts to contact a DHCP server in your network to obtain
its valid network settings, e.g., IP address, subnet mask and gateway address .
If your phone cannot contact a DHCP server, you need to configure network
settings manually.
(1) Press the ‘Menu’ soft key when the phone is idle, and then select Settings
For more information about account parameters, please refer to the user manual of the IP Phone.
Configure via the Web interface on your PC
Accessing the web interface on PC
(1) Press the key when the phone is idle to obtain the IP address of the phone.
(1)
Press the Menu soft key when the phone is idle, select Settings Advanced
Setting, input the default password ‘admin’, and then select Network LAN
Port, press .
Select Static IP or PPPoE. If you select static IP, you need to enter the IP
address, subnet mask and gateway address. If you select PPPoE, you need
to enter the usernameand password of the PPPoE account.
Press the Save soft key to accept the change. Then the network settings is
completed.
(2)
(3)
Advanced Setting, input the default password ‘admin’, and then select Account,
press .
Select an account to configure account information. The following is the
explanation of relevant parameters:
(2)
Open a web browser on your PC, enter the IP address into the address
bar(e.g., http://192.168.11.110'), and then press Enter.
(2)
To Next Page
Loading...