(314) 205-3033 WWW.DIODEDYNAMICS.COM
PAGE 1
Thank you for your purchase of our new LED Pod Ditch Light Kit.
CAD-designed to use existing mounting points, this kit is compatible
with the 2010+ Toyota 4Runner. Basic installation instructions are
included below. Please contact us if you have any questions.
See back for further instructions.
1. Starting on the driver side of the vehicle, mark the
location of the hood hinges with tape and tape the
edges of the hood to prevent scratching.
2. Remove the two 12mm bolts securing the hood
hinge, while holding the back of the hood. We also
highly recommend having someone else hold the
front of the hood to make sure it doesn’t close
when the bolts come out.
3. Place the ditch light bracket under the hinge and
align the holes with the hood hinge. Adjust the bracket
to leave a slight gap at the back of the hood before
tightening.
LED Pod Ditch Light Kit
5
th
Gen Toyota 4Runner
To Next Page
Need help?
General
