15
1) Make sure booster seat is properly positioned and installed on
vehicle seat as per the instructions in pages 8–9 and 13–14.
2) Properly position child: sitting upright and all the way back in
the booster seat.
3) Raise the headrest to access red upper belt guides.
A
Feed the
diagonal portion of the seatbelt through the guide on the side
opposite the seatbelt buckle.
4) Fasten seatbelt across child: Lap portion of seatbelt should rest
within both lower belt guides. Diagonal shoulder portion should
route inside the lower belt guide closest to the buckle and over
child’s shoulder.
Securing the Child
• If headrest is adjusted to maximum height and child’s shoulder height is closer than
1 cm to the upper belt guide, child is too tall and the seat can only be used a
backless booster.
WARNING:
• If lap portion and diagonal portion of seatbelt are not positioned correctly, the
booster seat is not properly installed:
• Diagonal portion of seatbelt should lay over the shoulder and NOT touching the neck.
• Lap belt position should be forward and as low as possible over child’s pelvis
and contacting the upper thigh.
EN_SP_cambria_Manual_09122017.indd 15 9/12/17 10:55 AM
To Next Page