REAR-FACING
50
3. Extend the LATCH/UAS strap.
For easier installation, extend the
LATCH/UAS strap to its maximum
length by pressing the grey
button and pulling on the strap.
4. Place car seat rear-facing in
back seat of the vehicle
with detachable rear-
facing base and ARP
installed. Center the car
seat between the vehicle
LATCH/UAS anchors. The seat
bottom and feet of the rear-
facing base should sit at on the
vehicle seat with no overhang.
5. Slide the LATCH/UAS strap
through the rear-facing belt
path and out the other side.
The LATCH strap should lie at
and not be twisted. The red
release loops on the connectors
should be facing up and
tightening mechanism should be
on the child’s left side of seat.
3
4
5
To Next Page
Loading...
