Introduction 3
Vehicle function compatibilities 4
Pre-installation and application warnings 5
OEM remote starter information 6
Installation 7
Wiring diagram with T-Harness (THTON6) 7
Wiring diagram 8
Locating components in the vehicle 9
Vehicle connections 11
Module programming 14
IMPORTANT!Before programming your module, you must first check if your vehicle is equipped with an OEM remote
starter and disable it. If the vehicle is equipped with an OEM remote starter, whether Active or Inactive, it must be
temporarily disabled or permanently disconnected depending on the vehicle. Please refer to the "OEM remote starter
information" section of the guide for additional details.Note: In some cases, the module will program to the vehicle
even if equipped with an OEM starter, but will prevent the aftermarket remote start from functioning properly. 13
Module programming for convenience only (skip transponder) 15
Module programming for security-only installations 16
Pairing remotes 17
Connecting the module 17
8556T Temperature Sensor 17
8504D Combo Sensor 17
RF Systems 17
When used in conjunction with SmartStart 18
D2D port configuration 18
Manual transmission 19
LED diagnostics and troubleshooting 20
Soft reset 22
Hard reset 22
Tach learning procedure (not needed with Virtual Tach) 23
Initializing Virtual Tach (not needed with hardwired or data tach applications) 23
Limited lifetime consumer warranty 24
Quick Reference Guide (customer copy) 25
Contents
To Next Page
Loading...
