13
© 2008 Directed Electronics - All rights reserved.
➢ Disarming without a transmitter
This feature allows you to disarm the security sys tem without the
remote trans mit ter should it be lost, dam aged, or disabled. In order
to dis arm the system with out a remote transmitter, you must have the
ve hi cle’s ig ni tion key and know where the Valet switch is located.
Be sure to check with the installer for the location and the number of
presses of the Valet switch required to disarm the system.
To disarm the security system,
turn the ignition to the ON po-
sition. Press the Valet switch
the preset number of times
(one to five times) within 15
seconds.
After 5 seconds, the sys tem will now disarm. If the system does
not disarm, you may have waited too long; turn the ignition off
and on and try again.
Location of Valet switch_________________________________
Number of Presses______________________________________
Important! The unit can be programmed to respond to one to five
presses of the Valet switch for the disarm function. Be sure to check
with the installer for the desired programming.
Online-store car audio and autogoods Winauto
winauto.ua
To Next Page
Loading...
Need help?
General
