Directed Electronics 2102T - User Manual

This product is intended for installation by a professional
installer only! Attempts to install this product by a person other than a
trained professional may result in severe damage to a vehicle’s electrical
system and components.
© 2012 Directed, Vista, CA
N2102T 2012-07
Directed Passive Keyless Entry (PKE)
Model 2102T
Installation Guide

Directed Electronics 2102T Specifications

General

Type	Car Alarm
Channels	2
Remote Start	Yes
Panic Mode	Yes
Keyless Entry	Yes
Shock Sensor	Yes
LED Status Indicator	Yes
Number of Buttons on Remotes	4
Range	Up to 1/4 mile
Remote Control	Yes
LCD Display	Yes
Starter Kill	Yes
Door Lock Control	Yes
Trunk Release	Yes
Valet Mode	Yes
Alarm Type	Audible
System Type	Two-way

Summary

Important Safety Precautions

Antenna Mounting and Installation

Vehicle Category Installation Specs

Installation Diagram

Type 1 - PKE Standalone

Wiring diagram for a standalone PKE installation without a remote starter.

Installation Diagram - Type 2 a

Installation Diagram - Type 2 b

Installation Diagram - Type 3 a

Installation Diagram - Type 3 b

Installation Diagram - Type 3 c

Installation Diagram - Type 4

Installation Diagram - Type 5

Installation Diagram - Type 6

Installation Diagram - Type 7

Installation Diagram - Type 8

Installation Diagram - Type 9

Wiring Connections

Analog Port Wiring

D2 D Port Wiring

Feature Programming

SmartLock Feature

Remote Pairing

Pairing FOB to PKE Module

Steps to pair the key fob with the PKE module for initial setup.

Pairing PKE to Remote Starter

Procedure to synchronize the PKE system with an installed remote starter module.

Factory Reset