22
© 2012 Directed� All rights reserved�
SmartLock feature
The purpose of the SmartLock feature is to prevent the doors from unwanted unlocking/locking when entering/exiting the
active zone multiple times for a pre-programmed delay (No delay*,1, 3 or 5 minutes). This is practical in situations such as
loading/unloading packages.
*SmartLock feature is disabled when it is set to no delay, which is confi gurable.
Note: If the Door Open Interlock feature is enabled, the SmartLock feature will not be able to lock a door when it is left opened.
For more information about using SmartLock feature, see owner's guide.
SmartLock feature diagram
1
2
3
FOB exits the zone: The doors lock, timer starts.
FOB re-enters the zone within the pre-programmed delay:
Doors unlock, timer is reset and stays frozen.
FOB exits the zone:
Doors stay unlocked, fresh timer re-starts.
4
FOB re-enters the zone within the pre-programmed delay:
Doors stay unlocked, timer is reset and stays frozen.
FOB exits the zone:
Doors stay unlocked, fresh timer re-starts.
The doors will automatically lock once the valid key fob remains
out of the active zone longer than the pre-programmed delay.
SmartLock feature CANCELLED.
SmartLock Feature ON
5
Step 3 & 4 will not
cause the doors to
lock/unlock as
long as the doors
are not opened/
closed during the
whole sequence.
To Next Page
Loading...
